After you change the setting, close the Primary program and try the WinTV application again. There should be a small black remote control icon listed in the System Tray. The driver for the device must be installed in order to run Prodinfo. If the Hardware Wizard detects the device, continue the installation of the drivers using the supplied installation CD Rom. The device must be reset in order to get it to work again.
|Date Added:||10 August 2013|
|File Size:||27.31 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The only way to reset the device is to recycle the power to it by unplugging the unit from the power cable for a few seconds then re-plugging it. If it is listed and there is a Yellow mark on it, this would indicate that the drivers would need to be reinstalled. After you change the setting, close the Primary program and try the WinTV application again. This is a single file which includes the driver, the driver update, middleware, video decoder and WinTV v6 applications and all accessories.
If you get the same problem, the hardware may be defective and require repair. Most third party capture applications are looking to attach to a card or driver that supports uncompressed video recordings.
This file is larger than the individual pieces, but should be easier to install since it is in one file.
Hauppauge WinTV-PVR-USB2 Specs – CNET
If you are still unable to use the remote control, this may be a hardware problem and would require repair of the device. Upon reboot, plug it in again and try WinTV again. If you click on it you should be able to open the WinTV programs. Installation CD Version 4. Please contact our Tech Support Dept at techsupport hauppauge. Once installation finishes, you should uzb2 able to use the program.
Recycle the power to it by unplugging the unit from the power usb for a few seconds then re-plugging it. Also refer to Intervideo Conflicts. If video does show up, the device is good. If you get a Black screen after scanning for channels, but you can hear the audio, try closing and reopening the program.
Contact Tech Support for more information. Also, the device does not use Video for Windows drivers.
There should be a small black remote control icon listed in the System Tray. If the channels are scanned in properly, they should be listed in the Suite Manager.
Hauppauge WinTV PVR-USB2 Drivers
The device must be reset in order to get it to work again. If you do not hear the audio, there may be a problem with the video decoders.
After reconnecting the device, try installing the application. First make sure witnv-pvr the IR Remote software is installed and running in the system tray. Here is where to find HCWClear: Wait a few moments and reconnect the power. You will need to reboot the system during installation. If the software is installed but you are unable to open or control the WinTV software with the remote control, the device may need to be reset.
If it is, unplug the power from the unit and restart the computer.
If it is not uzb2, this would normally indicate that the hardware was not recognized by the system and the drivers were unable to install. This error message can indicate a problem with the Driver installation or a hardware malfunction. Please make sure you have the latest version driver. Try inserting the channels manually to see if the video comes up.
Please refer to “Latest drivers and installation procedures” above.