Let HP identify any out-of-date or missing drivers and software How does HP use product data collected with this service? Turn off the computer before disconnecting any cables. To remove the lower 5. XMM3 socket, Channel B populate second. The appearance of the power supply varies based on model.

Uploader: Shajinn
Date Added: 21 March 2004
File Size: 49.71 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 17260
Price: Free* [*Free Regsitration Required]

HP Compaq dx2810 Quickspecs

Grasp the cable end of the connector and pull it straight up 2. You may want to lay the computer on its side to install internal parts.

Intel Celeron Dx28100 Processors: Let HP identify any out-of-date or missing drivers and software How does HP use product data collected with this service? Reset the date and time, your passwords, and any special system setups, using Computer Setup.

Disconnect the heatsink control cable from the system board and remove the heatsink Heatsink assembly.


This product detection tool installs software on your Microsoft Windows device that allows HP to detect and gather data about your HP and Compaq products to provide quick access to support information and solutions. Intel Core 2 Duo E Processor 3. If the access panel is removed while power is still supplied to the computer, the hood sensor will sound an alarm.

Internal PC speaker MT. The lifetime of the lithium battery can be extended by plugging the computer into a live AC wall socket.


HP Compaq dx2810/dx2818 Microtower PC Product Specifications

Maximum Refresh Rate Hz Resolution After installing a new processor onto the system board, always update the system ROM to ensure that the latest version of the BIOS is being used on the computer. Choose ‘Refresh’ to update the list. Nothing herein should be construed as constituting an additional warranty. The HP-supplied M3 metric guide screws 2 are black.

Do not rely on components like the drive cage, power supply, or computer cover to push cables down into the chassis. If you are replacing an old drive with a new drive, use the four retainer screws from the old drive to install the new drive.

Please try again shortly. I don’t see my operating system. Hood Sensor If the access panel is removed while there is still power to the computer, the hood sensor will cause the system to stop and display the Error message after system reboot and will beep 5 times for 5 seconds. The system will automatically operate in single channel mode, dual channel mode, or flex mode, depending on how the DIMMs are installed.

Be sure not to scrape the card against the other components.

HP Compaq dx Microtower PC – Driver Downloads | HP® Customer Support

The expansion slots accommodate full-height or half-height expansion cards. Refer to Installing Additional Bp for an illustration of the retainer screws location. Remove the front bezel Front Bezel.


Add to my manuals Add. Push the other edge down until the clamp snaps over the other edge of the battery. Connect the power cable 1 and data cable 2 to the rear of the optical drive. To install an external 3.

Modify your browser’s settings to allow Javascript to execute. The HP-supplied standard screws 1 are silver. The computer should automatically recognize the additional memory when you turn on the computer. Keep these numbers available for use when contacting customer service for assistance.

Regardless of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged into an active AC outlet.

You must disconnect the power cord and wait approximately 30 seconds for the power to drain before adding or removing memory modules. Locate the correct vacant expansion socket on the system board and the corresponding expansion slot on the back of the computer chassis.

Author: admin